JET-LUBE - WIREHOG Well Casing Brushes by Design Water
In wells, as much as 95% of debris created by biofouling (slime bacteria/iron bacteria) and 30-50% of mineral deposits may be on the inside of the well casing, screen or open bore hole. Wire brushing and removal of this debris will allow chemistry to more easily move into the aquifer, require less chemistry, and reduce the length on the job site significantly.

BENEFITS:
  • Rugged Construction
  • Sizes available to fit most well bores
  • Brush designs for steel or PVC pipes





 

 

Design Water Technologies

WireHog

Well Casing & Pipe Cleaning Brushes

WireHog Brushes

Description

3-10” diameter brushes. All have an 1.25” female coupling with FIP threads. 3 air holes are drilled in the fitting allow you to airlift debris without tripping out of the well. Use poly brushes for PVC casing and screen. Poly brushes can be used in steel pipe but will wear the brush. Use steel brushes for steel casing and screen. Do NOT use steel brushes in PVC as will etch the casing.

 

2” diameter brushes. These brushes have a 3/8” male, MIP fitting. Attach a 3/8” coupling to this fitting. If you want to airlift debris, drill 4-5 small diameter holes around the middle of the coupling. Adapt and connect to whatever diameter of steel pipe used for brushing. Airlift debris out of the well prior to chemical cleaning.

 

Application

Connect the fitting to 1.25” steel pipe for weight. Brush up/down in 20ʼ increments to the bottom of the well. You can brush and airlift simultaneously, if needed. At the bottom of the well, connect the pipe at the surface to your air-compressor and blow debris out of the well. If not enough submergence for airlifting, bail debris from the bottom of the well.

 

Steel Code #
Size
Poly Code #
Size
Get Assistance
Steel
DWT103
DWT106
DWT109
DWT112
DWT115
DWT118
DWT121

Steel
1.25 in assembly
2 in assembly
3 in assembly
4 in assembly
5 in assembly
6 in assembly
8 in assembly
Poly
DWT150
DWT153
DWT156
DWT165
DWT168
DWT171
DWT174
Poly
2 in assembly
3 in assembly
4 in assembly
5 in assembly
6 in assembly
8 in assembly
10 in assembly
Email for Assitance